[. . . ] [. . . ] . . SET UP NAME SET UP NAME . + < > > ENTER STR-DE485 ENTER STR-DE685 3. ) Press the '<' and '>' MENU buttons until the display on the front of the receiver reads the following: C. If you own an HT-DDW840 or STR-DE685 receiver, press the top or bottom of the JOG DIAL and toggle to the following setting: AV2 The system will automatically enter this mode as soon as you toggle to it. If you own an HT-DDW740 or STR-DE485 receiver, press the '+' and '-' MENU buttons until you see the AV2 setting (as mentioned above) After (5) five seconds, the display will return to the mode that it was in prior to performing this procedure. If you have performed this procedure and the Remote Commander still will not control your your receiver, try going carefully through the procedure again. [. . . ] [. . . ]